We will not disciminate..
- Email your rides here, pic w/info to - higg@ekustom.net
59 EDSEL 322 y-block power 4sp 457 spool street and strip
Duluth, GA
'48 Plymouth Special Deluxe Business Coupe Project.
MuntzGirl
53" MUNTZ RoadJet
The last factory assembled Jet, built in Evanston Illinois. One of approx
200 vehicles manufactured, with about a hundred of them left in the
world. Standard features included a "Carson" top and one of
the first production cars to have seatbelts, and the first with bucket
seats and a center console. Liquor bar in rear armrest was an option.
Alligator and snakeskin vinyl tuck-n-roll was standard! This car is
upholstered in "python." Lincoln motors were used. Car took
three years to build and is equipped with air-ride suspension, and a
Corvette LT-1 motor and trans. We just completed a twenty-seven hundred
mile roundtrip in it, San Diego to Seattle, without the liftoff top
or windshield wipers! Built and painted in my driveway!
Bartlett IL.
1950 Ford Cherry Bomb
1950 Ford 2door sedan .It has been a Kustom
Almost all its life. The 4 "chop was done over 40 years ago on the east coast, don’t know the history of this 50 but I am sure it has some. It has a Mustang II front end Dice brakes, dropped 6 "in the front and 4" in the back, the car stands 50" off the ground with no air ride candy red paint with white and Red Metal flake Interior .The engine is a 318 Mopar it was in it when I bought it runs down the road at 70 like a dream I do have a 425 nail head going in it next winter . This car was built to drive cross country.
President, VooDoo Kings Kustom Car Club
owner, Sideshow Kustoms Hanover Park, IL
53' Chevy 210 Sedan Radical Kustom too much to list
The T is a 1924 cowl with the rest of the body being homemade. The engine is a 1953 Ford Flathead back by a 1939 toploader tranny. Frame is a boxed 1924 Model T. Front axle is a 1932 A set up suicide style with 46 spindles and juice brakes. Grill shell is 1937 Chevy. Gas tank is off a Model T of some year. I cut the floor out of a sheet of 3/4 pressure treated plywood and the seats are old bar stools. Steering wheel is a 4 post sprint car style with a quick disconnect so i can remove it for quick exits during fires. Rims are 16" Budd wires with Firestone rubber. Most all the work was done by myself with a little help from friends.
Eric Brockmeyer
62' Rambler American.
It's got the original
flathead 6 and 3spd.
1930 Ford Model A
5 Window coupe.
camaro front disk, chevy 350 engine
1950 Shoebox For Sale.
In primer, Chopped, Channeled, Nosed, Decked, Shaved, , Lowered on Blocks, with 350/350 Chevy, Lakespipes(running), Genie shifter, new glass, new wide white Coker Bias Plys, new Edelbrock intake & carburetor. Have a lot of parts too.
markc@tvmagic.tv
cel 858-248-0527
Me and my Mo'
If ya gotta mow,,,do it with style!
JOE
FERRIS
(Lifters CC/So Cal)
1954 CHEVY KUSTOM LEAD SLED
FOR SALE
6 INCH CHOP, STRETCHED ROOFLINE, SUICIDE DOORS, ROUNDED
HOOD AND TRUNK CORNERS, FRENCHED ’59 CADILLAC TAILIGHTS, AIR BAG
SUSPENSION FRONT AND REAR, CAMARO SUBFRAME, 4 WHEEL DISK BRAKES, POWER
STEERING, RIDES LIKE A CADILLAC.,
$12000/OBO/MAY TRADE FOR HOT ROD
(619)200-1031
